MATEC Web Conf.
Volume 224, 2018International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|Number of page(s)||6|
|Section||Manufacturing Technologies, Tools and Equipment|
|Published online||30 October 2018|
Theoretical investigation of the effect of the taper angle of the deforming roller on the limiting degrees of deformation in the process of flow forming
Ural Federal University named after the first President of Russia B.N. Yeltsin, 19, Mira Street, Ekaterinburg 620002, Russia
2 Vyatka State University, 36, Moskovskaya Street, Kirov 610000, Russia
* Corresponding author: firstname.lastname@example.org
The conditions for the application of taper angles of deforming rollers are considered in the article, which ensure a steady flow of the flow forming. With the help of the developed engineering technique, analytical and graphical dependences of the boundary values of the deformation degrees on the cone angle of the deforming roller are obtained. The results of the theoretical study are in good agreement with the known experimental data. The developed engineering technique can be used in designing the flow forming on the direct and reverse method, as well as for any process of pressure treatment with a local focus of deformation.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.