MATEC Web Conf.
Volume 224, 2018International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|Number of page(s)||7|
|Section||Manufacturing Technologies, Tools and Equipment|
|Published online||30 October 2018|
Refinement issue of displaced volume at upsetting of cylindrical workpiece by radial dies
Peter the Great St. Petersburg Polytechnic University, Polytechnicheskaya, 29, St. Petersburg, 195251, Russia
2 Pryazovskyi State Technical University, Universytets’ka, 7, Mariupol, 87500, Ukraine
* Corresponding author: firstname.lastname@example.org
By analyzing the problem of upsetting of a workpiece by radial dies, an improved solution for determining the displaced volume was obtained. The value of the displaced volume is the basis for calculating such an important technological criterion as the engineering strain range of the workpiece during the upsetting. It is revealed that the main difficulty lies in calculating the volume that is placed between the contact surface and the end protuberances of the deformed workpiece, which requires the involvement of numerical or tabular integration methods that do not provide a complete solution.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.