Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
---|---|---|
Article Number | 01028 | |
Number of page(s) | 7 | |
Section | Manufacturing Technologies, Tools and Equipment | |
DOI | https://doi.org/10.1051/matecconf/201822401028 | |
Published online | 30 October 2018 |
Deviation from flatness of surfaces after combined peripheral grinding
Institute of Engineering and Automobile Transport, Vladimir State University, Gorky street 87, Vladimir, 600000, Russian Federation
* Corresponding author: prof_gusev@mail.ru
A new method of combined flat peripheral grinding is examined, which allows to carry out simultaneously preliminary and final machining of the planes without replacing the coarse with the fine-grain grinding wheel, to eliminate the auxiliary time for the tool replacement, to correct it and set the grinding equipment in order to accomplish the given size. An experimental multifactor model which relates the surfaces flatness deviation with independent factors of the combined grinding process is established on the basis of which it is possible to assign the cutting conditions that provide the required flatness with the greatest possible longitudinal and cross-feed of the blank.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.