Issue |
MATEC Web Conf.
Volume 204, 2018
International Mechanical and Industrial Engineering Conference 2018 (IMIEC 2018)
|
|
---|---|---|
Article Number | 07019 | |
Number of page(s) | 10 | |
Section | Construction | |
DOI | https://doi.org/10.1051/matecconf/201820407019 | |
Published online | 21 September 2018 |
Experimental investigation of design parameters for laboratory scale Pelton wheel turbine using RSM
Mechanical Engineering Department, State University of Malang, 65145 Malang, Indonesia
*
Corresponding author: avita.ayu.ft@um.ac.id
Response Surface Methodology (RSM) is used in this study as an experimental design to obtain optimum conditions for each parameter. This study uses pelton turbines on a laboratory scale. The purpose of this study is to determine the optimum number of buckets and flow rates against turbine performance. The performance measured in this study is turbine efficiency. RSM is used to obtain mathematical equations from the performance of the turbine at optimum conditions. The optimum results obtained from RSM is to improve the performance of Pelton turbines that are 15,7714 (16 pieces) and flow rate of 0.1583 ℓ / s (0.16 ℓ / s) resulting in turbine efficiency of 29.16%.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.