| Issue |
MATEC Web Conf.
Volume 198, 2018
2018 Asia Conference on Mechanical Engineering and Aerospace Engineering (MEAE 2018)
|
|
|---|---|---|
| Article Number | 04003 | |
| Number of page(s) | 4 | |
| Section | Electronic Engineering and Mechatronics | |
| DOI | https://doi.org/10.1051/matecconf/201819804003 | |
| Published online | 12 September 2018 | |
Dynamic Simulation Studies of Control Design for Engine Bleed Air Test Facility
Shanghai Aircraft Design and Research Institute, Commercial Aircraft Corporation of China Ltd, Shanghai, China
This paper describes a model-based method for the control design of engine bleed air test facility for the bleed air system. In order to perform the control design, a dynamic simulation model for the facility is developed to simulate the dynamic behaviour. The main equipment dynamic modelling approaches are described. This simplified dynamic model may be used to perform trade studies and to optimize component characteristics for performance and cost comparison purposes. With the performance shown, this engine bleed air test facility should be quite capable to emulate the engine for bleed air system testing and evaluation.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.