MATEC Web Conf.
Volume 184, 2018Annual Session of Scientific Papers IMT ORADEA 2018
|Number of page(s)||4|
|Section||Machines Engineering and Technologies|
|Published online||31 July 2018|
T3D end milling finite element thermal analysis
Visoka škola tehničkih strukovnih studija Čačak, Svetog Save 65, 32000 Čačak, Serbia
2 UNS Faculty of Fechnical Sciences, Trg Dositeja Obradovića 6, 21000 Novi Sad, Serbia
3 Technical university in Kosice Kosice, Slovakia
* Corresponding author: firstname.lastname@example.org
The paper presents a modern approach to the phenomenon of thermal analysis in end milling by the finite element method. 3D model of the end mill and work-piece was created in the software package SolidWorks. In order to predict the occurrence of thermal phenomena in milling process software package Third Wave AdvatEdge was used. Influence of cutting speed on the temperature in cutting zone was modelled and analyzed.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.