Issue |
MATEC Web Conf.
Volume 184, 2018
Annual Session of Scientific Papers IMT ORADEA 2018
|
|
---|---|---|
Article Number | 02015 | |
Number of page(s) | 4 | |
Section | Mechatronics and Robotics | |
DOI | https://doi.org/10.1051/matecconf/201818402015 | |
Published online | 31 July 2018 |
Modelling and simulation of a series wound direct current motor using ANSYS
1
Mechatronics Department, Faculty of Engineering, University of Debrecen, Hungary
* Corresponding author: k.ist96@mailbox.unideb.hu
In this paper we will discuss the process of making the model of a series wound DC motor and performing simulation and analysis using the ANSYS products. The geometry model was done in RMXprt, and the electromagnetics simulation in MAXWELL. Using the data acquired from those analyses a thermodynamical simulation was also done on the geometric model.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.