| Issue |
MATEC Web Conf.
Volume 178, 2018
22nd International Conference on Innovative Manufacturing Engineering and Energy - IManE&E 2018
|
|
|---|---|---|
| Article Number | 02001 | |
| Number of page(s) | 6 | |
| Section | Assembling Technologies, Forming Technologies, Additive Manufacturing | |
| DOI | https://doi.org/10.1051/matecconf/201817802001 | |
| Published online | 24 July 2018 | |
Simple equipment for studying the injection molding process
“Gheorghe Asachi” Technical University of Iasi, Blvd. 59A, 700050 Iasi, Romania
* Corresponding author: hrituc.adelina3295@yahoo.com
The injection molding process is largely applied to obtain plastic parts. The problem of finding a simple equipment able to allow the study of the injection process was addressed in the research presented in this paper. Aiming to solve the problem, the main requests valid for the proposed equipment were formulated. Considering some possible versions of the equipment subassemblies, the ideas diagram method and the method of imposed decision were applied to select the most convenient version of the injection equipment. As a result, a constructive solution for a simple injection molding equipment that could be used to develop some experimental researches was identified.
© The Authors, published by EDP Sciences, 2018.
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.