| Issue |
MATEC Web of Conferences
Volume 172, 2018
3rd International Conference on Design, Analysis, Manufacturing and Simulation (ICDAMS 2018)
|
|
|---|---|---|
| Article Number | 04004 | |
| Number of page(s) | 5 | |
| Section | Manufacturing Engineering | |
| DOI | https://doi.org/10.1051/matecconf/201817204004 | |
| Published online | 12 June 2018 | |
Selection of cutting parameters for the machinability of Inconel 718 using Grey Relational Analysis
Department of Mechanical and Automobile Engineering, Christ University Faculty of Engineering, India
* Corresponding author: ivan.rout@christuniversity.in
Inconel 718 is considered to be most difficult to machine superalloy because of its high shear strength, work hardening and precipitation hardening. Abrasive particles which are in microstructure have tendency have forming chip to be welded to tool and form built up edge (BUE) making it more difficult to machine. Friction between tool and material and its low thermal conductivity results in high temperature generation. Certain tools such as Ceramics are present which machine this material at prime cutting conditions. This paper addresses the cutting parameters needed most for providing low surface roughness
Key words: Friction Stir Welding / Destructive Test (DT) / Non-Destructive Test (NDT)
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.