Issue |
MATEC Web Conf.
Volume 167, 2018
2018 3rd International Conference on Mechanical, Manufacturing, Modeling and Mechatronics (IC4M 2018) – 2018 3rd International Conference on Design, Engineering and Science (ICDES 2018)
|
|
---|---|---|
Article Number | 02004 | |
Number of page(s) | 5 | |
Section | Mechanical and Manufacturing Engineering | |
DOI | https://doi.org/10.1051/matecconf/201816702004 | |
Published online | 23 April 2018 |
Transverse and Longitudinal Stress Analysis in Reinforced Welded Oil Branched Pipes
National Iranian South Oil Company (NISOC), Ahvaz, Iran
Department of Mechanical Engineering, Shohadaye Hoveizeh University of Technology, Khuzestan, Iran
Department of Mechanical Engineering, Shahid Chamran University of Ahvaz, Ahvaz, Iran
a Hossein.safari86@gmail.com; r.pourrajab@gmail.com
Welding process results in the non-uniform distribution of heat. Combined with thermal strain, plastic deformation and welding-induced distortion, it causes important problems such as failure. This study models welding process in a 12×16 split tee junction using finite element. This junction is a reinforcing branch used in the hot taping of oil pipe line. The model is studied in 3D state. This zone, i.e. heat affected zone (HAZ) is of high importance due to the existence of a severe temperature gradient and stress in the vicinity of HAZ. This study analyses single pass butt welding with a cooling time of 2700 seconds. In order to apply boundary conditions to the model, the studied structure should be in Free State according to practical procedure. The main aim of this simulation is to analyse Longitudinal and transverse residual stresses originated from co-directional and opposite-directional welding. This joint is formed of two semicircles welded to each other as linear single pass welding. Two welders simultaneously welded both sides of the pipe.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.