MATEC Web Conf.
Volume 165, 201812th International Fatigue Congress (FATIGUE 2018)
|Number of page(s)||9|
|Published online||25 May 2018|
Determination of the anisotropic fatigue behaviour of additively manufactured structures with short-time procedure PhyBaLLIT
Institute of Materials Science and Engineering, TU Kaiserslautern, 67663 Kaiserslautern, Germany
2 State Materials Testing Institute Darmstadt (MPA), Chair and Institute for Materials Technology (IfW), Technische Universität Darmstadt, 64283 Darmstadt, Germany
* Corresponding author: firstname.lastname@example.org
Additive Manufacturing techniques provide completely new possibilities in component design and creation of innovative material structures. To utilize the whole potential of Additive Manufacturing, the microstructure, the mechanical properties and their interrelations as well as their relationship to the Additive Manufacturing process parameters are essential. Investigations of the fatigue behaviour of additively manufactured (AM-) metallic materials are still available in limited extent. However, as a prerequisite for efficient and reliable use of AM-components in safety relevant structures, sound knowledge of fatigue behaviour and properties of these structures is indispensable. A central aspect in Additive Manufacturing is the anisotropic mechanical behaviour under monotonic and cyclic loading in dependency on the building direction [1, 2]. In the present work, the microstructure and mechanical properties of Selective Laser Melted (SLM) as well as Laser Deposition Welded (LDW) AISI 316L stainless steel specimens are investigated with special focus on the influence of the building direction. The investigated specimens are built in horizontal and vertical direction, resulting in layer planes oriented parallel and perpendicular to the loading direction, respectively. The fatigue tests have been performed on a servohydraulic testing system with measurement of stress-strain-hysteresis as well as of plastic deformation induced changes in temperature and specific electrical resistance. S-Nf-curves in the HCF-regime of AM-specimens have been determined with the time and material efficient Physically Based Lifetime calculation procedure PhyBaLLIT . Anisotropic fatigue behaviour of the different AM-specimens has been rated with load increase tests (LIT) and the usage of S-Nfcurves calculated by the PhyBaLLIT method.
Key words: Additive Manufacturing / load increase tests / PhyBaLLIT / fatigue behaviour / anisotropy / 316L
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.