MATEC Web Conf.
Volume 157, 2018Machine Modelling and Simulations 2017 (MMS 2017)
|Number of page(s)||7|
|Section||Modelling and simulation, structural optimization|
|Published online||14 March 2018|
Identifying the cause of cutting tool failure by using simulation software
Univeristy of Žilina, Faculty of Mechanical Engineering, Univerzitná 1, 010 26 Žilina
* Corresponding author: email@example.com
The article is focused on the construction problems of cutting tools designed for manufacturing components in high numbers. Analysis of the tool with low lifetime is provided with the use of simulation software to detect the causes of the tool failure. Parameters of the simulation are close to the real conditions of the tool in production. The results from the simulation indicate that the bending moment occurs in the tool because of forces which have opposite direction on different areas. On these basis technological adjustments are made. These adjustments are also analysed by using simulation software.
Key words: cutting tool / stress analysis / failure of cutting tool / position of energy force
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.