Issue |
MATEC Web Conf.
Volume 157, 2018
Machine Modelling and Simulations 2017 (MMS 2017)
|
|
---|---|---|
Article Number | 02036 | |
Number of page(s) | 8 | |
Section | Modelling and simulation, structural optimization | |
DOI | https://doi.org/10.1051/matecconf/201815702036 | |
Published online | 14 March 2018 |
Heat flow and heat transfer coefficient during crystallization under the pressure
Department of technological engineering, University of Žilina, Univerzitná 8215/1, 01026 Žilina
* Corresponding author: richard.pastircak@fstroj.uniza.sk
Estimation of the heat flow at the metal-mold interface is necessary for accurate simulation of the solidification processes. For the numerical simulation, a precise prediction of boundary conditions is required to determine the temperature distribution during solidification, porosity nucleation, microstructure development, and residual stresses. Determination of the heat transfer coefficients at the metal-mold interface is a critical aspect for simulation of the solidification process and the microstructure modeling of the castings. For crystallization under the pressure and for thin-walled castings, HTC evaluation is important due to the very limited freezing time.
Key words: Squeeze casting / HTC / Heat flow / Pressure.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.