Issue |
MATEC Web Conf.
Volume 157, 2018
Machine Modelling and Simulations 2017 (MMS 2017)
|
|
---|---|---|
Article Number | 02005 | |
Number of page(s) | 9 | |
Section | Modelling and simulation, structural optimization | |
DOI | https://doi.org/10.1051/matecconf/201815702005 | |
Published online | 14 March 2018 |
Flap casting of turbine engine optimization by numerical simulation
University of Žilina, Faculty of Engineering, Department of technological engineering, Univerzitná 1, 01026 Žilina, Slovakia
* Corresponding author: rapture.marko@gmail.com
Submitted article focuses on possibilities of increasing internal quality of flap casting of turbine engine produced by investment casting technology. Material porosity will be eliminated by altering the gate system. ProCast software has been used to evaluate and analyse the design of the flap. The aim of the research was to evaluate the porosity of the cast after its solidification, the flow velocity of the melted material and visualise the turbulence of the flow during casting. Main aim will be to observe and analyse velocity, flow, turbulences, solidification and internal porosity for nickel based alloy.
Key words: Numerical simulation / investment casting / porosity
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.