MATEC Web Conf.
Volume 244, 2018Innovative Technologies in Engineering Production (ITEP’18)
|Number of page(s)||7|
|Section||Development Trends in Machining Technology|
|Published online||05 December 2018|
The evaluation of the surface quality after laser cutting
VŠB - Technical University of Ostrava, Faculty of Mechanical Engineering, 17. listopadu 15/2172, Ostrava - Poruba, 708 33, Czech Republic
2 Instytut Materiałów Inżynierskich i Biomedycznych, Konarskiego 18a, 44-100 Gliwice, Poland
* Corresponding author: email@example.com
The contribution deals with the evaluation of the surface quality after laser cutting and determination of the influence individual input laser parameters at the whole process. There were selected samples for experiment made from S235JR material with the thickness 10 mm and 15 mm. There was set up values of process parameters, such as laser power, focal spot position, cutting speed and shield gas pressure. The final surface quality was measured and evaluated on the basis of the selected surface roughness parameters and material ratio. The surface quality was evaluated from point of view of defects emerging after thermal splitting according to standard ČSN EN ISO 17 658.
Key words: Laser Cutting / Cutting Parameters / Surface Roughness / Abbott-Firestone Curve
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.