Issue |
MATEC Web Conf.
Volume 244, 2018
Innovative Technologies in Engineering Production (ITEP’18)
|
|
---|---|---|
Article Number | 01028 | |
Number of page(s) | 9 | |
Section | Progressives Technologies | |
DOI | https://doi.org/10.1051/matecconf/201824401028 | |
Published online | 05 December 2018 |
Possibilities of applying motif group parameters for description roughness of turned surfaces
1
Wrocław University of Science and Technology, Faculty of Mechanical Engineering. ul. Łukasiewicza 5, 50-371 Wrocław, Poland
2
University of Žilina, Faculty of Mechanical Engineering, Univerzitna 1, 010 26, Žilina, Slovakia
* Corresponding author: maciej.kowalski@pwr.edu.pl
This article explores the methodology of assessing the applicability of roughness parameters from the motif group to the evaluation of one-way and periodic geometrical surface structures. The results of surface roughness measurements of aluminum samples turned with variable kinematic parameters were presented. Usability of using surface motifs in combination with selected parameters described in ISO standards for assessment of geometrical structures characteristic for longitudinal turning was shown.
Key words: Aluminum alloys / Surface geometrical structure / Roughness parameters
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.