MATEC Web Conf.
Volume 137, 2017Modern Technologies in Manufacturing (MTeM 2017 - AMaTUC)
|Number of page(s)||8|
|Published online||22 November 2017|
The analysis of instantaneous tool displacements during precise ball end milling
Poznan University of Technology, Faculty of Mechanical Engineering and Management, Institute of Mechanical Technology, Poznan, Poland
* Corresponding author: firstname.lastname@example.org
The paper presents the quantitative and qualitative analysis of monolithic ball end mill’s instantaneous displacements generated during precise milling of inclined surfaces. The conducted experiment involves the measurements of tool’s joining part displacements with the application of laser displacement sensor and cutting forces with piezoelectric dynamometer. The milling tests were carried out for the hardened alloy 55NiCrMoV6 steel in a range of variable feed per tooth and surface inclination angle values. The obtained results can be applied for the selection of effective milling parameters allowing the improvement of machined surface finish.
© The authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.