| Issue |
MATEC Web Conf.
Volume 137, 2017
Modern Technologies in Manufacturing (MTeM 2017 - AMaTUC)
|
|
|---|---|---|
| Article Number | 05004 | |
| Number of page(s) | 8 | |
| Section | Metal Forming | |
| DOI | https://doi.org/10.1051/matecconf/201713705004 | |
| Published online | 22 November 2017 | |
Selected properties of galvanic coatings shaped using thermal drilling technology
1 Poznan University of Technology, Faculty of Mechanical Engineering and Management, Institute of Materials Technology, Poznan, Poland
2 Poznan University of Technology, Faculty of Mechanical Engineering and Management, Institute of Materials Science and Engineering, Poznan, Poland
* Corresponding author: waldemar.matysiak@put.poznan.pl
The paper presents the investigations of mechanical properties and microstructure of materials formed by thermal drilling process (Flow drill). The aim of this study was to determine the microstructure of the surface layers produced using galvanic method on the low-carbon steel after formed this layer using thermal drilling technology. The coatings of copper and nickel thicknesses of 5, 10 and 15 μm were applied. Microstructure, chemical composition and microhardness was study. It was found the possibility of forming galvanic coatings using thermal drilling technology and change in chemical composition of treated material.
© The authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.