| Issue |
MATEC Web Conf.
Volume 129, 2017
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2017)
|
|
|---|---|---|
| Article Number | 01033 | |
| Number of page(s) | 4 | |
| Section | Modern Manufacturing Technologies, Tools and Equipment | |
| DOI | https://doi.org/10.1051/matecconf/201712901033 | |
| Published online | 07 November 2017 | |
Technological system self-tuning when milling
1
Lipetsk State Technical University, 398600, 30, Moskovskaya Str., Lipetsk, Russia
2
PJ-SCo. ‘Novolipetsky Metallurgical Complex’, 398040, 2, Metallurgists’ Square, Lipetsk, Russia
3
Bryansk State Technical University, 241000, 7, 50 let Octyabrya Blvd, Bryansk, Russia
* Corresponding author: kiryuschenko_ev@nlmk.com
This paper reports the dynamics of the technological system during the milling of complex parts and the investigations of possibility in efficiency increase of a cutting process at the expense of conditions creation for a system self-tuning at which a general level of oscillations will not decrease in it. This can be achieved with a special damping device located on the machine screw gears supports. In this case, if the period of the wave on the cutting surface does not coincide with the period of natural oscillations, then there will be no resonance, and the level of oscillations will be much smaller.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.