MATEC Web Conf.
Volume 121, 20178th International Conference on Manufacturing Science and Education – MSE 2017 “Trends in New Industrial Revolution”
|Number of page(s)||10|
|Section||Management, Modelling and Monitoring of Manufacturing Processes|
|Published online||09 August 2017|
Researches regarding cutting tool condition monitoring
1 Lucian Blaga University of Sibiu, Industrial Engineering and Management Department, Victoriei, 10, 550025, Sibiu, Romania
2 Politehnica University of Bucharest, IMST Faculty, Spl. Independentei, 313, Bucharest, Romania
* Corresponding author: firstname.lastname@example.org
The paper main purpose is monitoring of tool wear in metal cutting using neural networks due to their ability of learning and adapting their self, based on experiments. Monitoring the cutting process is difficult to perform on-line because of the complexity of tool wear process, which is the most important parameter that defines the tool state at a certain moment. Most of the researches appraise the tool wear by indirect factors such as forces, consumed power, vibrations or the surface quality. In this case, it is important to combine many factors for increasing the accuracy of tool wear prediction and establish the admissible size of wear. For this, paper both the theoretical data obtained from FEM analyze and experimental ones are used and compared in order to appreciate the reliability of the results.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.