MATEC Web Conf.
Volume 121, 20178th International Conference on Manufacturing Science and Education – MSE 2017 “Trends in New Industrial Revolution”
|Number of page(s)||9|
|Section||Design, Manufacturing and Management of Technological Equipment and Systems|
|Published online||09 August 2017|
Superficial hardened layer of cut surface by turning
1 Politehnica University of Bucharest, Faculty of Engineering and Management of Technological Systems, Machines and Production Systems Dept., 313 Spl. Independentei, 6 Sector, 060042 Bucharest, Romania
2 Politehnica University of Bucharest, Faculty of Engineering and Management of Technological Systems, Materials Technology and Welding Dept., 313 Spl. Independentei, 6 Sector, 060042 Bucharest, Romania
3 Politehnica University of Bucharest, Faculty of Engineering in Foreign Languages, 313 Spl. Independentei, 6 Sector, 060042 Bucharest, Romania
* Corresponding author: firstname.lastname@example.org
One of research methods in metal cutting process is to measure hardness in the contact zone between cutting tool and workpiece. The objective of the performed research was to determine thickness and hardness of the superficial layer of cut surface due to cutting process, both orthogonal and complex cutting. The most important finding was that thickness of the superficial hardened layer is very thin under considered conditions, less than 0.01 … 0.02 mm. This research should be continued.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.