| Issue |
MATEC Web Conf.
Volume 121, 2017
8th International Conference on Manufacturing Science and Education – MSE 2017 “Trends in New Industrial Revolution”
|
|
|---|---|---|
| Article Number | 01013 | |
| Number of page(s) | 8 | |
| Section | Design, Manufacturing and Management of Technological Equipment and Systems | |
| DOI | https://doi.org/10.1051/matecconf/201712101013 | |
| Published online | 09 August 2017 | |
Analysis of justification for applying two gear sets within the universal gear reducers
University of Novi Sad, Faculty of Technical Sciences, 6 Trg Dositeja Obradovića, 21000 Novi Sad, Serbia
* Corresponding author: racmil@uns.ac.rs
In the area of universal gear reducers, standard does not prescribe relations between load capacity, gear ratios and axis heights. Therefore, larger load capacity of some gear reducers manufacturers has advantage for lower gear ratio and, vice versa, smaller load capacity of the gearbox achieves higher values of gear ratio. However, there are some manufacturers who produce gear reducers with smaller or larger load capacity for higher or lower gear ratio, within the same axis height. This paper deals with analysis of justification of applying two gear sets, especially in the case when so-called intermediate sizes of gear reducer are not used.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.