| Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
|---|---|---|
| Article Number | 05014 | |
| Number of page(s) | 6 | |
| Section | Flexible Manufacturing, Automation and Robotics in Technological Processes | |
| DOI | https://doi.org/10.1051/matecconf/201711205014 | |
| Published online | 03 July 2017 | |
Grouping of parts for co-processing on flexible rotor lines
Donetsk National Technical University, Department of Manufacturing Engineering, 58, Artyom Street, Donetsk, Ukraine
* Corresponding author: bulenkov@ukr.net
The problem of parts combining for group processing on flexible rotary lines is considered in this article. The advantages of group processing in a single tool unit in terms of performance and metal consumption of lines are presented in this article. The technique of parts combining for group processing is proposed in this paper.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.