MATEC Web Conf.
Volume 112, 201721st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|Number of page(s)||6|
|Section||Flexible Manufacturing, Automation and Robotics in Technological Processes|
|Published online||03 July 2017|
Algorithms of control parameters selection for automation of FDM 3D printing process
Silesian University of Technology, Faculty of Mechanical Engineering, Institute of Engineering Processes Automation and Integrated Manufacturing Systems, Konarskiego 18A, 44-100 Gliwice, Poland
* Corresponding author: firstname.lastname@example.org
The paper presents algorithms of control parameters selection of the Fused Deposition Modelling (FDM) technology in case of an open printing solutions environment and 3DGence ONE printer. The following parameters were distinguished: model mesh density, material flow speed, cooling performance, retraction and printing speeds. These parameters are independent in principle printing system, but in fact to a certain degree that results from the selected printing equipment features. This is the first step for automation of the 3D printing process in FDM technology.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.