| Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
|---|---|---|
| Article Number | 02009 | |
| Number of page(s) | 6 | |
| Section | Assembling Technologies, Forming Technologies | |
| DOI | https://doi.org/10.1051/matecconf/201711202009 | |
| Published online | 03 July 2017 | |
Considerations about the influence of lubricant in different machining mechanical processes
Gheorghe Asachi Technical University of Iasi, Department of Machine Manufacturing and Industrial Management, Blvd. Dimitrie Mangeron no. 59A, Iasi, Romania
* Corresponding author: nagit@tcm.tuiasi.ro
There are numerous researches that highlight the fact that wear related processes of machine components are one of the main causes which leads to their destruction. The main reasons for wear are related to the initial state of contact surfaces described by mechanical and physical properties of their superficial layer. Thus friction surface’s state depends on previous mechanical machining done on this surface especially the last one. This study presents a method which proposes and creates premises for a microgeometry favorable to maintaining the lubricant on part surfaces for as long as possible dependent on different machining processes. Comparisons are made between values specific to the wear state of the considered part obtained by various machining by measuring material mass removed during functioning in similar working conditions.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.