Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
---|---|---|
Article Number | 02008 | |
Number of page(s) | 6 | |
Section | Assembling Technologies, Forming Technologies | |
DOI | https://doi.org/10.1051/matecconf/201711202008 | |
Published online | 03 July 2017 |
A numerical solution for a closed die forging process
“Gheorghe Asachi” Technical University of Iaşi, Department of Technologies and Equipments for Materials Processing, 51, Prof.dr.doc. Dimitrie Mangeron Street, 700050 Iaşi, Romania
* Corresponding author: dluca@tuiasi.ro
One of the manufacturing processes that can be permanent improved is plastic deformation of metallic materials, as incorporating reserves on the manufacture of products with reduced material and energy consumptions. This paper presents finite element analysis for a closed die forging process, showing the stresses, strains and temperature into deformed part and stresses in the working tools. The analysis of obtained results for different flash dimensions of the working tools has enabled optimization of the forging process studied. To be able to validate the numerical results obtained, experimental tests were conducted. The compared data series show a good agreement between the numerical and experimental data.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.