MATEC Web Conf.
Volume 90, 2017The 2nd International Conference on Automotive Innovation and Green Vehicle (AiGEV 2016)
|Number of page(s)||8|
|Published online||20 December 2016|
State of art of cooling method for dry machining
1 Faculty of Mechanical Engineering, Universiti Malaysia Pahang, 26600 Pekan, Pahang, Malaysia
2 Automotive Engineering Centre, Universiti Malaysia Pahang, 26600 Pekan, Pahang, Malaysia
* Corresponding author: firstname.lastname@example.org
The usage of cutting fluid in the machining operations will not only poses health risk to the workers but also creates environmental challenges associated with fluid treatment and disposal. The objective of this review paper is to identify present cooling method in dry machining and novel feature than can be included in the cooling system for a better heat removal which tend to increase machining performance. From the review study, it shows that cooling method by internal manner is most widely been researched because researcher believes that it has a promising future in adaptive machining to produce a contamination free products which supports the green manufacturing concept. The suggested novel feature is ecologically desirable and it will become as a necessity for improving the performance of dry machining in the near future.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.