Issue |
MATEC Web Conf.
Volume 108, 2017
2017 International Conference on Mechanical, Aeronautical and Automotive Engineering (ICMAA 2017)
|
|
---|---|---|
Article Number | 04008 | |
Number of page(s) | 4 | |
Section | Mechanical Engineering | |
DOI | https://doi.org/10.1051/matecconf/201710804008 | |
Published online | 31 May 2017 |
Effect of contact angle and helix angle on slide-roll ratio under the uniform motion state of BSM
Key Laboratory of Advanced Manufacturing Technology, Beijing University of Technology, Beijing 100124, China
To study the effect of contact and helix angles on slide-roll ratio at the ball contact point under the uniform motion state of ball screw mechanism (BSM), a slide- roll ratio model was derived in the literature [9] were used in this paper. It also conducts a simulation analysis of the slide-roll ratio relationship between the uniform motion at the ball center and ball contact point under different contact angle and helix angle. As shown by the analysis, with the increase in the BSM’s contact angle, the slide/roll ratio at the contact point decreased, and the contact angle had a relatively significant effect on the slide/roll ratio; however, with the decrease in the BSM’s helix angle, the slide/roll ratio at the contact point decreased, and helix angle had a relatively insignificant effect on the slide/roll ratio.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.