| Issue |
MATEC Web Conf.
Volume 100, 2017
13th Global Congress on Manufacturing and Management (GCMM 2016)
|
|
|---|---|---|
| Article Number | 04025 | |
| Number of page(s) | 6 | |
| Section | Part 4: Equipment manufacturing and New materials | |
| DOI | https://doi.org/10.1051/matecconf/201710004025 | |
| Published online | 08 March 2017 | |
Model-based Adjustment of Droplet Characteristic for 3D Electronic Printing
1 Beijing Shenzhou Aerospace Software Technology Co. Ltd., Beijing, China
2 School of Mechanical Engineering, Beijing Institute of Technology, Beijing, China
3 School of Computer Science and Software, Tianjin Polytechnic University, Tianjin, China
4 Department of Electrical and Computer Engineering, Lehigh University, Bethlehem, USA
a linn@htrdc.com
b jingshikai@126.com
c perfect_chn@hotmail.com
d wliu@lehigh.edu
The major challenge in 3D electronic printing is the print resolution and accuracy. In this paper, a typical mode - lumped element modeling method (LEM) - is adopted to simulate the droplet jetting characteristic. This modeling method can quickly get the droplet velocity and volume with a high accuracy. Experimental results show that LEM has a simpler structure with the sufficient simulation and prediction accuracy.
Key words: Model-based adjustment / Droplet characteristic / 3D electronic printing
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.