| Issue |
MATEC Web Conf.
Volume 80, 2016
NUMIFORM 2016: The 12th International Conference on Numerical Methods in Industrial Forming Processes
|
|
|---|---|---|
| Article Number | 03004 | |
| Number of page(s) | 6 | |
| Section | MS3: Defects and damage prediction in forming processes | |
| DOI | https://doi.org/10.1051/matecconf/20168003004 | |
| Published online | 24 October 2016 | |
Evaluation of ductile failure models in Sheet Metal Forming
1 INEGI, Institute of Science and Innovation in Mechanical and Industrial Engineering, R. Dr. Roberto Frias 400, 4200-465 Porto, Portugal
2 FEUP, Faculty of Engineering, University of Porto, R. Dr. Roberto Frias, 4200-465 Porto, Portugal
a Corresponding author: ramaral@inegi.up.pt
Traditionally, combination of equivalent plastic strain and stress triaxiality parameters are taken into account when performing characterization of material ductility. Some well-established models like Lemaitre model, GTN based models and many others perform relatively well at high-triaxiality stress states but fail to give adequate answers to low-triaxiality states. In this work, three damage models are presented, applied and assessed to a cross-shaped component. Concerning material, AA5182-O, corresponding damage parameters are characterized by an inverse analysis procedure for each damage model.
© The Authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.