| Issue |
MATEC Web of Conferences
Volume 34, 2015
2015 2nd International Conference on Mechatronics and Mechanical Engineering (ICMME 2015)
|
|
|---|---|---|
| Article Number | 02012 | |
| Number of page(s) | 5 | |
| Section | Mechanical design and manufacturing | |
| DOI | https://doi.org/10.1051/matecconf/20153402012 | |
| Published online | 11 December 2015 | |
Study on Tool Path Optimization in Multi-axis NC Machining
1 Tianjin Key Laboratory of the Design and Intelligent Control of the Advanced Mechatronical System, Tianjin 300384, China
2 Tianjin University of Technology, Tianjin 300384, China
a Corresponding author: Xinghua Niu, niu_x_h@126.com
This paper presents a new generation algorithm for tool path based on the optimization of traditional algorithms. Then, the tool path on an impeller is generated with UG software, and it is used to make contrasts and verifications for the effect of optimization. Finally, VERICUT software with the function of the simulating on the whole manufacturing process is utilized to verify the feasibility of the optimized algorithm.
Key words: NC machining / path optimization / UG / VERICUT
© Owned by the authors, published by EDP Sciences, 2015
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.