MATEC Web of Conferences
Volume 31, 20152015 7th International Conference on Mechanical and Electronics Engineering (ICMEE 2015)
|Number of page(s)||4|
|Section||Mechanical design manufacturing and automation|
|Published online||23 November 2015|
Analysis and Research of Structure and Process Characteristic Based on Low Rigidity Shell Part
Department of numerical design & manufacture Changchun Research Institute of Equipment and Technology, Changchun, 130012 P.R. China
* Corresponding author: firstname.lastname@example.org
The process design is a very important step in NC machining which will ensure the manufacturing quality of the part. For the low rigidity part, due to the low rigidity and high deformation under certain load, herein, the low rigidity part often shows more clamping deformation under clamping force and cutting force in manufacturing, so that it will lead to machining error out of tolerance. In this paper, we choose a low rigidity shell part as research target, the machining process will be designed and analyzed, two clamping schemes were designed for this part, and the comparison and analysis were finished by using finite element method (FEM), the results showed that the smaller deformation and error was obtained in the axial clamping scheme, therefore, we choose this scheme as the ultimate clamping scheme for the low rigidity shell part.
© Owned by the authors, published by EDP Sciences, 2015
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.