Open Access
MATEC Web Conf.
Volume 195, 2018
The 4th International Conference on Rehabilitation and Maintenance in Civil Engineering (ICRMCE 2018)
Article Number 02013
Number of page(s) 10
Section Structural Engineering
Published online 22 August 2018
  1. B. Budiono, and C. Adella, Penggunaan isolasi dasar single friction pendulum dan triple friction pendulum pada bangunan beton bertulang, Jurnal Teknik Sipil, Vol. 22 No. 2, pp. 67-78 (2015) [Google Scholar]
  2. S Camelia., Vasile., and Lazar., Mathematical formulation of friction pendulum system with multiple sliding interfaces, RJAV, Vol. 8, No. 1, pp. 41 (2011) [Google Scholar]
  3. L. Petti, F. Polichetti, A. Lodato, and B. Palazzo, Modelling and analysis of base isolated structures with friction pendulum system considering near fault events, Open Journal of Civil Engineering, Vol. 3, pp. 86-93 (2013) [CrossRef] [Google Scholar]
  4. A. Barmo, I.H Mualla, and H.T. Hasan, The behaviour of multi-story buildings seismically isolated system hybrid isolation (friction, rubber and with the addition of rotational friction dampers), Open Journal Civil Engineering Vol. 4, pp. 1-13 (2013) [CrossRef] [Google Scholar]
  5. M. Sarkisian, P. Lee, E. Long, D. Shook, and A. Diaz, Experiences with friction pendulumtm seismic isolation in California, Earthquake Resistant Engineering Structures, Vol. 132, pp. 357-368 (2013) [CrossRef] [Google Scholar]
  6. N. Kravchuk, R, Colquhoun, and A. Probaha, Development of a friction pendulum bearing base isolation system for earthquake engineering education, Proceedings of the 2008 American Society for Engineering Education Pacific Southwest Annual Conference (2008) [Google Scholar]
  7. R.L. Mayes, the seismic design handbook, published in Berkeley, California (2000) [Google Scholar]
  8. T.C. Becker, Advanced modelling of the performance of structures supported on triple friction pendulum bearing, Dissertation, Civil and Environmental Engineering, University of California, Berkeley (2011) [Google Scholar]
  9. M. Naguib, F.A. Salem, and K. El-Bayoumi, Dynamic analysis of high rise seismically isolated buildings, American Journal of Civil Engineering, Vol. 3, No. 2, pp. 43-50 (2015) [CrossRef] [Google Scholar]
  10. N.R. Marrs, Seismic performance comparison of a fixed-base versus a base isolated office building, Master Thesis, Architectural Engineering, Faculty of California Polytechnic State University, San Luis Obispo (2013) [Google Scholar]
  11. Y.M Al-Anany, and M.J Tait, Experimental assessment of utilizing fibre reinforced elastomeric isolators as bearings for bridge applications, Composites Part B, Vol. 114, pp. 373-385 (2017) [CrossRef] [Google Scholar]
  12. Oiles Corporation, (accessed 16 June 2017) [Google Scholar]
  13. SYSTRA Consulting Group Company, (accessed 1 January 2017) [Google Scholar]
  14. SNI Committee, Tata cara perencanaan ketahanan gempa untuk struktur bangunan gedung dan non gedung (SNI-1726-2012), Badan Standarisasi Nasional Indonesia, Jakarta (2012) [Google Scholar]
  15. ASCE Committee, Minimum Design Loads for Buildings and Other Structures (ASCE/SEI 7-10), Structural Engineering Institute, American Society of Civil Engineering, Reston, Virginia (2010) [Google Scholar]
  16. Pusat Penelitian dan Pengembangan Jalan dan Jembatan, Ministry of Public Works and Housing of the Republic of Indonesia, (accessed 3 January 2017) [Google Scholar]
  17. D. Gasparini and E.H. Vanmarcke, SIMQKE: A Program for Artificial Motion Generation, Department of Civil Engineering, Massachusetts Institute of Technology, Cambridge, Mass, USA, 1976. [Google Scholar]
  18. AASHTO Committee, American Association of State Highway and Transportation Officials, Guide Specification for Seismic Isolation Design, Washington DC (2010) [Google Scholar]
  19. NCHRP 20-7, Seismic isolation design examples of highway bridges, Final Report, University of Nevada Reno (2011) [Google Scholar]
  20. Soletanche Freyssinet Group, (accessed 7 April 2017) [Google Scholar]
  21. K. EL-Bayoumi, Modelling of triple friction pendulum bearing in SAP2000, International Journal of Advances in Engineering & Technology Vol. 8 Issue 1 p p. 1964-1971 (2015) [Google Scholar]
  22. A. Tambusay. Cyclic behaviour slab-column connections using the engineered cementitious composite, Dissertation, Faculty of Civil Engineering and Planning, Institut Teknologi Sepuluh Nopember, Surabaya, Indonesia (2017) [Google Scholar]
  23. A. Tambusay., P. Suprobo., Faimun, and A.A Amiruddin., Finite element modelling of a reinforced concrete slab-column connection under cyclic lateral load, International Journal of Applied Engineering Research, ISSN 0973-4562, Vol. 12, No. 9, pp. 1987-1993 (2017). [Google Scholar]
  24. A. Tambusay., P. Suprobo., Faimun, and A.A Amiruddin., Finite element analysis on the behaviour of slab-column connections using PVA-ECC material, Jurnal Teknologi (Science and Engineering), Vol. 79, No. 5, pp. 23-32 (2017) [Google Scholar]

Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.

Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.

Initial download of the metrics may take a while.