MATEC Web Conf.
Volume 367, 202221st Conference on Power System Engineering
|Number of page(s)||10|
|Published online||14 October 2022|
Numerically modelling temperature deformations and stresses in the exhaust system of a gas compressor unit
University of West Bohemia, 22 Univerzitni, Pilsen, 32600, Czechia
2 NAEK Energoatom, 22-24 Hoholivska, Kyiv, 01032, Ukraine
3 Sumy State University, 2 Rymskogo-Korsakova, Sumy, 40007, Ukraine
* Corresponding author: email@example.com
During the operation of a gas compressor unit, the temperature of the exhaust system can cause failure or burnout of the inner facing sheets of the unit. The article describes a technique for determining the maximum temperature deformations of these elements. The technique enables more accurate calculation of the temperature deformations by determining the influence of the contacts between the inner facing and the power frame on the temperature distribution and mobility of the exhaust system. The temperature deformations and stresses of the exhaust system elements are determined, and the level of the permissible stresses is evaluated. The results of the work can be used to prevent possible ruptures and burning of the inner facing, as well as to calculate the design dimensions of the lens expansion joint.
© The Authors, published by EDP Sciences, 2022
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.