MATEC Web Conf.
Volume 346, 2021International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2021)
|Number of page(s)||9|
|Published online||26 October 2021|
Influence of Design and Technological Parameters of Disk Working Bodies on the Height of the Crest of the Bottom of the Furrow
1 Chair “Processes and machines in agribusiness” of the faculty of mechanization of Kuban State Agrarian University named after I.T.Trubilin, 350044, Krasnodar, Russia
2 Experimental farm «Krasnodarskoe» of Kuban State Agrarian University named after I.T.Trubilin, 350044, Krasnodar, Russia
* Corresponding author: firstname.lastname@example.org
Disks are one of the most common tillage working bodies used both on independent machines and tools, and as part of combined aggregates. Compliance with agrotechnical requirements is a necessary condition for improving the technological efficiency of the disk working bodies. The height of the furrow bottom ridge depends on a number of design and technological parameters of adjacent disks, as well as the distance between them. In the article, analytical expressions are obtained that allow us to describe the relationship between the height of furrow bottom ridge formed between the projections of cutting edges of adjacent disks, structural and technological parameters, and a given orientation scheme.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.