| Issue |
MATEC Web Conf.
Volume 346, 2021
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2021)
|
|
|---|---|---|
| Article Number | 02007 | |
| Number of page(s) | 7 | |
| Section | Materials Science | |
| DOI | https://doi.org/10.1051/matecconf/202134602007 | |
| Published online | 26 October 2021 | |
Composite Corundum Ceramics with Reinforcing Carbon Nanotubes Modified with Eutectic Additives
D. Mendeleev University of Chemical Technology of Russia, 9 Miusskaya square, Moscow, Russia, 125047
* Corresponding author: nmakarov@muctr.ru
The characteristics of composite materials of Al2O3 system - carbon nanotubes - eutectic additives are investigated. The influence of the reinforcing component content, as well as the mode of high-temperature heat treatment in vacuum on the strength properties of the material are considered. Samples with a mass content of carbon tubes of 0.4% were obtained. These samples had the following characteristics: an average tensile strength at three-point bending of 380 MPa, an open porosity of 0.9%, an average density of 3.71 g/cm3.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.