| Issue |
MATEC Web Conf.
Volume 321, 2020
The 14th World Conference on Titanium (Ti 2019)
|
|
|---|---|---|
| Article Number | 10007 | |
| Number of page(s) | 8 | |
| Section | Melting and Casting | |
| DOI | https://doi.org/10.1051/matecconf/202032110007 | |
| Published online | 12 October 2020 | |
Revisited: gas-saturated defects in titanium alloys
1 PSC «VSMPO-AVISMA Corporation»
* moleder@vsmpo-avisma.ru, puzakov@vsmpo-avisma.ru, tarenkova@vsmpo.ru, kornilova@vsmpo.ru, rusakov_ka@vsmpo.ru
The simulation results of the internal defects generated during deformation by extrusion and rolling are presented herein. It was demonstrated that end-type deformation defects can result in the formation of internal gas-saturated defects not cropping out the surface under the specific deformation conditions. Key characteristics of the generated defects similar to those of the production defects that have been previously classified as metallurgical are determined.
Key words: defect, deformation, discontinuity.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.