MATEC Web Conf.
Volume 299, 2019Modern Technologies in Manufacturing (MTeM 2019)
|Number of page(s)||6|
|Section||Additive Manufacturing and Non-traditional Technologies|
|Published online||02 December 2019|
Research on improving the accuracy of FDM 3D printing process by using a new designed calibrating part
Department of Manufacturing Engineering, Faculty of Machine Building, Technical University of Cluj-Napoca,
B-dul Muncii 103-105,
2 Department of Mechatronics and Machine Dynamics, Faculty of Automotive, Mechatronics and Mechanical Engineering, Technical University of Cluj-Napoca, B-dul Muncii 103-105, 400641, Cluj-Napoca, Romania
The article presents theoretical and experimental research methods that were used at the Technical University of Cluj-Napoca (TUCN) to improve the accuracy of Fused Deposition Modeling (FDM) 3D printing process. Finite element analysis method was successfully used for estimating the shrinkages of an original calibrating part that has been originally conceived for this purpose, this part being finally made using an original software application and FDM 3D printing equipment at TUC-N.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.