| Issue |
MATEC Web Conf.
Volume 298, 2019
International Conference on Modern Trends in Manufacturing Technologies and Equipment: Mechanical Engineering and Materials Science (ICMTMTE 2019)
|
|
|---|---|---|
| Article Number | 00141 | |
| Number of page(s) | 6 | |
| DOI | https://doi.org/10.1051/matecconf/201929800141 | |
| Published online | 18 November 2019 | |
Consideration of hydraulic limitations in setting the mode parameters of combined piercing the holes
Novosibirsk State Technical University, Faculty of Mechanical Engineering and Technologies, 630073 Prospekt K. Marks 20, Novosibirsk, Russia
* Corresponding author: vasilevskaya@corp.nstu.ru
The paper considers the hydrodynamic limitations in the combined machining, caused by the non-rigidity of the tubular cathode-tool. It is shown that increasing the inertia moment of the cathode-tool cross section is possible only in decreasing the diameter of the hole for pumping the electrolyte. It should be noted that reducing the diameter of the hole increases the hydrodynamic losses of the electrolyte flow in the hydraulic path and, as a result, leads to a significant reduction in the range of the mode regimes. Thus, to implement the combined piercing of deep holes of small diameter, it is necessary to quantify the hydrodynamic limitations in using the tubular cathode-tool of significant length to establish the mode parameters.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.