Issue |
MATEC Web Conf.
Volume 292, 2019
23rd International Conference on Circuits, Systems, Communications and Computers (CSCC 2019)
|
|
---|---|---|
Article Number | 01057 | |
Number of page(s) | 6 | |
Section | Circuits and Systems | |
DOI | https://doi.org/10.1051/matecconf/201929201057 | |
Published online | 24 September 2019 |
The automated system for bandsaw blade properties measurement
1 TBU in Zlin, Dept. of Automation and Control Engineering, Faculty of Appl. Informatics, Nad Stranemi 4511, Zlin, Czech Rep.
2 TBU in Zlin, Dept. of Electronics and Measurements, Faculty of Applied Informatics, Nad Stranemi 4511, Zlin, Czech Republic
* Corresponding author: sysala@utb.cz
The article describes the bandsaw blade properties innovative method design and realization. The introduction contens individual bandsaw parts description, including their important parameters overview. The innovative methods design delineation follows. The constructed device based on our design minimizes the human error influence. Moreover, it is collecting and archiving measured data. The article covers also the design and software realization. In the end, some measured data examples are stated.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.