Issue |
MATEC Web Conf.
Volume 210, 2018
22nd International Conference on Circuits, Systems, Communications and Computers (CSCC 2018)
|
|
---|---|---|
Article Number | 04045 | |
Number of page(s) | 6 | |
Section | Computers | |
DOI | https://doi.org/10.1051/matecconf/201821004045 | |
Published online | 05 October 2018 |
A system for band saw wheel wear measurement
1
TBU in Zlin, Dept. of Automation and Control Engineering, Faculty of Appl. Informatics, Nad Stranemi 4511, Zlin, Czech Republic
2
TBU in Zlin, Dept. of Electronics and Measurements, Faculty of Applied Informatics, Nad Stranemi 4511, Zlin, Czech Republic
* Corresponding author: sysala@utb.cz
The article describes the design and application of a new method for the band saw parts wear grade measurement. The introduction mentiones the individual parts of a band saw in general, and it states the current method of band pass wheels wear measurement. The nowadays measurement method analysis and innovative method design follows. The article also contains the design realization and related software description. The practical measurements data samples are present together with design benefits in the Data Analysisi Section.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.