MATEC Web Conf.
Volume 290, 20199th International Conference on Manufacturing Science and Education – MSE 2019 “Trends in New Industrial Revolution”
|Number of page(s)||12|
|Section||Advanced Manufacturing Technologies|
|Published online||21 August 2019|
Simulation of the Single Point Incremental Forming of Polyamide and Polyethylene Sheets
Faculty of Engineering, Department of Industrial Engineering and Management, „Lucian Blaga” University, Sibiu, Romania
* Corresponding author: firstname.lastname@example.org
The present paper aims the theoretical study, using the finite element method, on the single point incremental forming process of two polymeric materials: polyamide 6.6 and high-density polyethylene. The experimental researches used for the determination of the true stress - true strain curves for two materials are presented, which are necessary for their introduction into the simulation. The explicit analysis is carried out with the Ls-Dyna program and the results of the analysis were focused on the major strain, minor strain, thickness reduction, forces on the process and total energy consumed in the process.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.