| Issue |
MATEC Web Conf.
Volume 286, 2019
14th Congress of Mechanics (CMM2019)
|
|
|---|---|---|
| Article Number | 04001 | |
| Number of page(s) | 3 | |
| Section | Integrated Design and Production, Manufacturing Processes | |
| DOI | https://doi.org/10.1051/matecconf/201928604001 | |
| Published online | 14 August 2019 | |
The optimization of a hydroformed tube
1
LMPGI, EST Casablanca, Université Hassan II, Morocco
2
LIMII, F.S.T Settat, BP: 577, Route de Casa, Settat– Morocco
The shaping by hydroforming process involves several complex phenomena and presents several types of nonlinearities (geometric, material,...). The development of a hydroforming operation requires a lot of testing to determine with precision the optimum loads of trips and get a room without defects. Advances in digital tools have enabled manufacturers to simulate and optimize their production facilities before launching the production in order to minimize the maximum rate of defective parts.
Key words: tube / hydroforming / optimization.
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.