MATEC Web Conf.
Volume 265, 2019International Geotechnical Symposium “Geotechnical Construction of Civil Engineering & Transport Structures of the Asian-Pacific Region” (GCCETS 2018)
|Number of page(s)||6|
|Section||Construction Management and Economics|
|Published online||30 January 2019|
Anthropotechnic reliability of materials and products for non-collapsible and collapsible systems
Moscow State University of Civil Engineering, Yaroslavskoe shosse, 26, Moscow, 129337, Russia
* Corresponding author: firstname.lastname@example.org
In engineering systems, which are used in construction industry and its production (buildings, constructions, roads), two fundamentally different ways of mechanical joint are used: non-collapsible and collapsible. Some architects relate non-collapsible objects to monolithic and consider their recycling as a difficult and expensive process. Compression joints on self-locking fittings can be considered as non-collapsible as well. A compression connection cannot be disassembled without destroying. Collapsible joint differs from non-collapsible by the following features: 1. You can disassemble it to original components according to a prior technology, identify and change defective elements or add some other components. 2. It requires periodic inspection and maintenance because of climatic conditions (temperature changes, pressure changes, wind loads, etc.), and the specificity of operation of this joint leads to a decrease in its mechanical properties. 3. It is forbidden to make them monolithic, so collapsible joints are mounted in an accessible way.
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Initial download of the metrics may take a while.