MATEC Web Conf.
Volume 240, 2018XI International Conference on Computational Heat, Mass and Momentum Transfer (ICCHMT 2018)
|Number of page(s)||4|
|Section||Mathematical Modeling in the Energy and Industrial Processes|
|Published online||27 November 2018|
3-D simulation using for hydraulic calculation of the heat Accumulator
Ukrainian State University of Railway Transport, Feuerbach Square 7, 61050 Kharkov, Ukraine
* Corresponding author: email@example.com
The article is devoted to the peculiarities of hydraulic calculation of the heat accumulator in the software environment for 3D modeling - SolidWorks. Based on the results of the calculation, the values of the distribution of the velocities of the water flow and the distribution of the static pressure in the given plane of the heat accumulator were obtained, which eventually made it possible to identify the problem areas in the three-dimensional model and obtain the values of the pressure difference.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.