Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
---|---|---|
Article Number | 02106 | |
Number of page(s) | 5 | |
Section | General problems of mechanical engineering: design, optimization, maintenance | |
DOI | https://doi.org/10.1051/matecconf/201822402106 | |
Published online | 30 October 2018 |
Synthesis of methods and principles of ensuring the reliability of one-off and serial production machines
1
Don State Technical University, The Faculty of Road-Transport, Russia
2
Don State Technical University, The Faculty of Civil Engineering, Russia
* Corresponding author: a123lok@mail.ru
The paper considers the development of methods for managing the reliability of single-production machines (lunar rover, rover, rolling mill, president’s car of the country, etc.). Many years of experience in the field of machine reliability allowed the leading specialists of the department of AS and DS to develop a method for managing reliability for serial and mass machines. in the case of evaluating the reliability of single-production machines, development of algorithms based on sample data and data obtained during the transition from the sample to the set of values was carried out. The resource of the parts is defined as the main parameter, which, irrespective of their purpose, form the sampled samples of units of finite volume. Given that the main parameter of the details the resource depends on the strength and loading parameters, the correlation between the strength parameters and the acting stresses (endurance limit, active stress in the dangerous section, strength increase coefficients and the coefficient of increasing the acting voltage) is used in the studies. In such conditions, the estimated resource should relate to each entity of the population or a sample from it. During the research, a parameter is defined as the minimum resource that will determine the homogeneity of the sample (the aggregate), while the main condition for ensuring the same main parameters of parts with sudden failures is the Veler-Sørensen-Kogayev formula based on the experimental initial fatigue and loading statistics . Thus, a method has been developed to ensure the reliability of single-source machines, based on the synthesis of two methods and principles for serial and single-purpose machines.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.