| Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
|---|---|---|
| Article Number | 01132 | |
| Number of page(s) | 5 | |
| Section | Manufacturing Technologies, Tools and Equipment | |
| DOI | https://doi.org/10.1051/matecconf/201822401132 | |
| Published online | 30 October 2018 | |
Interrelation of processing modes with the current parameters of the contact zone during thermofriction processing
Sevastopol State University, Department of Food Technologies and Equipment, 299053 Sevastopol, Russia
* Corresponding author: nik.pokintelitsa@mail.ru
The establishment of the interrelation between the processing modes and the current parameters of the contact zone during the thermofriction processing of flat surfaces of workpieces by a rotating disk tool is considered. Dependencies are presented allowing assignment of cutting modes, prediction of the size of the removed material layer, and determination of the control actions value.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.