| Issue |
MATEC Web Conf.
Volume 190, 2018
5th International Conference on New Forming Technology (ICNFT 2018)
|
|
|---|---|---|
| Article Number | 04005 | |
| Number of page(s) | 4 | |
| Section | Cold forming | |
| DOI | https://doi.org/10.1051/matecconf/201819004005 | |
| Published online | 18 September 2018 | |
Numerical modelling of T-pipe joints forming
Lublin University of Technology, 36 Nadbystrzycka, 20-618 Lublin, Poland
*
Corresponding author: j.bartnicki@pollub.pl
This paper presents results of numerical calculations of T-pipe joints (tee) forming process for a wide scope of industrial applications. FEM analyses were conducted for the chosen process technological parameters and tools designs. The kinematics of metal flow in the area of the formed flanges was analysed. Distributions of stresses, strains and damage criterion during forming were determined. Calculated values of forces and moments acting on tools and workpieces allow for designing of tools geometry for experimental verification of the proposed forming process.
Key words: FEM / design / optimization / cold forming
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.