| Issue |
MATEC Web Conf.
Volume 175, 2018
2018 International Forum on Construction, Aviation and Environmental Engineering-Internet of Things (IFCAE-IOT 2018)
|
|
|---|---|---|
| Article Number | 02025 | |
| Number of page(s) | 3 | |
| Section | Building Equipment Automation | |
| DOI | https://doi.org/10.1051/matecconf/201817502025 | |
| Published online | 02 July 2018 | |
Study on optimization experiment and characteristic test of biomass granule forming machine
School of Mechanical Engineering, University of Jinan, Jinan 250022, Shandong Province, China
*
Corresponding author : 87756997@qq.com
According to the biomass pellet fuel forming machine, problems such as high energy consumption, easy clogging, and low efficiency exist in the granulation process. In this paper, corn and wheat stalks are used as raw materials to study the effects of the size of the raw materials and the moisture content on the formation rate, particle average length, particle density, mechanical durability, and heating value of the particulate fuel. The influence of parameters such as spindle speed and die diameter on the productivity, molding rate, mechanical durability, and particle density of the molding machine was investigated. Compressor and ANSYS were used to study the compression characteristics and flow characteristics of corn stalk, and the characteristics of the pellets were determined. The results showed that the corn stalk with a grain size of 4 mm with a moisture content of 14% and wheat straw with a grain size of 4 mm with a moisture content of 15% had high molding rate, good particle density, and good mechanical durability.
© The Authors, published by EDP Sciences 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.