MATEC Web Conf.
Volume 165, 201812th International Fatigue Congress (FATIGUE 2018)
|Number of page(s)||6|
|Section||Creep-Fatigue Interactions / Fatigue at Very High Temperatures|
|Published online||25 May 2018|
Creep-fatigue interaction in heat resistant austenitic alloys
Department of Management and Engineering, Linköping University, 58183 Linköping, Sweden
2 AB Sandvik Materials Technology R&D Center, 81181 Sandviken, Sweden
* Corresponding author: firstname.lastname@example.org
This work includes an investigation of two commercial austenitic steels: UNS S21500 (Esshete 1250) and UNS S31035 (Sandvik SanicroTM 25). The materials were exposed to isothermal strain controlled fatigue with load controlled dwell time at maximum strain. The testing temperature used was 700°C and the test cycles were performed in tension. Mechanical test data were obtained and analysed in order to define creep-fatigue damage diagrams at failure for the investigated austenitic alloys. During the given conditions, Sanicro 25 showed superior creep-fatigue life, suffered less amount of creep elongation for the same amount of strain amplitude and dwell times compared to Esshete 1250. Both alloys showed creep-fatigue interaction damage for specific test configurations.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.